How To Fill Rinse Aid And Detergent Dispenser; 7-1.How To Fill Rinse Aid; How To Fill Detergent Dispenser - Haier DW12-TFE3 Series Service Manual

Service Manual
Issue
Model No.DW12-TFE3 Series
Rev.

7. How to fill rinse aid and detergent dispenser

7-1.How to fill rinse aid

7-1-1.Rinse aid
This product makes dishes sparkle and helps them to dry without spotting.
The dispenser is located on the inside panel of the door .
When the low rinse aid indicator " H " lights , you must load rinse aid .
7-1-2.Loading the rinse aid
Regardless of the type of detergent dispenser installed
on your appliance, you must proceed as indicated below
when loading the rinse aid.
To open the dispenser, turn the "2" cap in an anti-clockwise direction and
then pour in the rinse aid, making sure not to overfill. The amount of
rinse aid used for each cycle can be regulated by turning the " 3" dose
adjustor, located beneath the "2" cap, with a screwdriver. There are 6
different settings; the normal dosage setting is 3.
Important
Proper dosage of the rinse aid improves drying. If drops of water remain on the dishes or
spotting occurs, the dosage adjustor should be turned to a higher setting. If the dishes
have white streaks, turn the dosage adjustor to a lower setting.

7-2. How to fill detergent dispenser

7-2-1.Detergent
Detergent specifically intended for use with dishwashers
must be used. The dispenser must be refilled before the
start of each wash cycle following the instructions
provided in the "Programme overview". The detergent
dispenser is located on the inside panel of the door.
7-2-2.Loading the detergent
--To open the " 4 " cover on the dispenser, press the " 5 "
button.
--The detergent for the wash cycle should be poured into
the " 6 " compartment.
--The detergent for the pre-wash cycle should be poured
into the " 7 " compartment.
--After the detergent has been placed in the dispenser,
25