In1 Function; 9-8.Reset Drain Function - Haier DW12-TFE3 Series Service Manual

Service Manual
Model No.DW12-TFE3 Series

9-7. 3 in1 function

When using "3 in 1"combination products, the rinse-aid and salt lights are no longer useful. It may
be helpful to select the lowest possible setting for water hardness.
If you decide to switch to the use of a standard detergent system we advise that you:
Refill both the salt and rinse aid compartments.
Switch the water hardness setting to the highest possible position and run for three normal cycles
without a load.
Readjust the water hardness setting again according to the conditions for your region (For more
information please refer to your instruction manual).
Warning
Do not place the tablets in the tub or the cutlery basket as this will result in poorer wash
results. The tablets should be placed in the detergent doser.
Notice:
The usage of 3 in 1 or similar tablets is forbidden when Heat, Rapid Wash and Soak
programmes are selected.

9-8.Reset drain function

You can use Reset drain function to stop the washing cycle under running by Rotating the knob to
"Reset ", and the appliance will stop after a few minutes drain phase.
31
Issue
Rev.