Hardware Reset
Reset Button
The reset button is used to reset the system or restore the factory default settings� Sometimes
resetting the system can return the camera to normal operation� If the system problems remain
after reset, restore the factory settings and install again�
Reset: Press and release the recessed reset button with a straightened paper clip. Wait for the
Network Camera to reboot�
Restore: Press and hold the recessed reset button until the status LED rapidly blinks. Note that
all settings will be restored to factory default� Upon successful restore, the status LED will blink
green and red during normal operation�
Micro SD/SDHC/SDXC Card Capacity
This network camera is compliant with Micro SD/SDHC/SDXC 8/16/32/64GB and other
preceding standard SD cards�
LED Definitions
Item
LED Status
1
Steady
Red
Red
LED off
2
Steady
Red
+ blinking
LED on for 1 sec and off for another)
Steady
Red
+
3
Blinking
Red
every 1 sec�
(Red
LED on for 1 sec� and off for another)
4
Blinking
Red
every 0�15 sec
Green
every 1 sec�
Green
LED off
every 0�15 sec� + Blinking
LED on for 0�15 sec� and
every 0�15 sec� + blinking
Description
Power on and system booting
Powered off
(Green
Network heartbeat
Network disconnected
Green
Upgrading firmware
Green
Green
Restoring defaults
VIVOTEK
User's Manual - 7