Table of Contents
Advertisement
CROP-CUT ADJ.
TEST PRINT
To check the test pattern (C&C1)
Check to make sure that the printing position and the cutting position are aligned.
Printing position and Cutting position
are misaligned.
CROP-CUT ADJ.
TEST PRINT 2
To check the test pattern (C&C2)
The point where the cutting line intersects the correction-value scale is the correction value. Check
the scan direction and feed direction respectively.
Correctionvalue scale
Feed direction
CROP-CUT ADJ.
SETTING
Performing Printing and Cutting Separately
Press
.
The test pattern (C&C1) is printed and cut.
When adjustment is needed, go on to the next Procedure.
Cutting position
Printing position
Printing position and Cutting position
are aligned.
Press
to display the left figure.
Press
.
The test pattern (C&C2) is printed and cut.
Scan direction
Cutting line
Press
to display the left figure.
Press
.
Cutting line
For the figure, the correction
value is "-0.3."
4
135
Advertisement
Table of Contents
