Switch; Adjusting The Stationary Vise - RIDGID CM1450 Owner's Manual

Basic Operations (continued)
WARNING: To reduce the risk of
injury from unexpected tool
movement:
a. Before moving this tool, lock
the power head in the lower
position. Unplug electric cord.
b. To reduce the risk of back
injury, hold the tool close to
your body when lifting. Bend
your knees so you can lift with
your legs, not your back. Lift by
using the hand-hold areas at
each side of the bottom of the
base or by the carrying handle.
c. Never carry tool by the power
cord or the trigger grip of the
plastic handle. Carrying the

Switch

On/Off Trigger Switch - To start the tool,
squeeze the trigger. To stop the tool,
release the trigger.
Repositioning the Stationary Vise
The stationary vise can be repositioned
by removing the vise adjustment bolt.
Loosen the miter lock handle and reposi-
tion the stationary vise in one of the other
two hole locations. Replace and tighten
the vise adjustment bolt.The maximum
width capacity is approximately 8-1/4" at
90° and 5" at 45°.
tool by the power cord could
cause damage to the insulation
or the wire connections result-
ing in electric shock or fire.
d. Place the machine so other
people cannot stand behind it.
Thrown debris could injure
people in its path.
e. Place the tool on a firm, level
surface where there is plenty of
room for handling and properly
supporting the workpiece.
f. Support the tool so the table is
level and does not rock.
g. Bolt or clamp the tool to its
support.
Base
18
On/Off
Trigger
Switch
Miter Lock
Screw
Handle
Shaft
Stationary
Vise
Vise
Adjustment
Bolt