Mounting Switch And End Caps; Securing Electrical Cords - RIDGID Contractor TS2424 Owner's Manual

Mounting Switch and End Caps

1. From the bag labeled "Miscellaneous" remove only the
following hardware:
2 Pan Head Screws, 10-32 x 3/8" Long
2 Lockwashers, #10 External Type
2 Square Nuts, 10-32
4 Pan Head Screws, Type "AB" 8 x 1/2" Long
2 Rear Stop Washers
From the bag labeled "Trim" remove the following:
4 Plastic End Caps
1 Key Switch
2. Insert the 2 10-32 x 3/8" pan head screws with lock-
washers through the outermost holes in switch assem-
bly.
3. Install the 2 square nuts on the screws so that there is
an 1/8"+ clearance between the inside of the nut and
the top of the switch assembly bracket.
NOTE: Switch assembly may be mounted on left or right
hand side of saw.
Mounting Switch on Right Side
1. Slide the nuts into the lower slot of the front guide bar
from the right end, with the switch facing front.
2. Slide switch assembly left until the left side of switch
assembly is in line with right side of main saw table -
tighten screws.
Mounting Switch on Left Side
1. Slide the nuts into the lower slot of the front guide bar
from the left end, running wire behind unit, with switch
facing front.
2. Slide the assembly right until the right side of the
switch assembly is in line with the left side of the main
saw table - tighten screws.

Securing Electrical Cords

1. From the bag labeled "Large Parts" find the following:
3 Wire Ties
Switch Mounted on Right Side
2. Route motor cord and power cord along right side of
cabinet. Use a hammer to lightly tap the pointed tabs
on the wire ties into the two holes provided on the right
side of cabinet. Secure both cords in wire ties.Loop
motor cord in rear wire tie to remove excess slack.
NOTE: One wire tie is extra.
Switch Mounted on Left Side
1. Route motor cord and power cord along left side of
cabinet. Use a hammer to lightly tap the pointed tabs
on the wire ties into the three holes provided on the left
side of the cabinet. Secure both cords through wire
ties.
Pan Head Screw
10-32 x 3/8"
Type "AB" 8 x 1/2
Pan Head Screw
10-32
Square Nut
Rear Stop Washer
Square Nut
Key Switch
Front Guide
Bar
Switch Assembly
Wire Tie
33
#10 External
Lockwasher
Plastic End Caps
Bracket
Lockwasher
10-32 x 3/8 Pan
Head Screw
Wire Tie
Two Cords