Keys; Passenger Workstation - Winnebago Vista User Manual

2
1. Lower the dinette table.
2. Route the tether over the top of the dinette seat
back and hook it to the anchor loop on the floor.
3. Fasten the lap belt.
-Typical Installation
Model E35F
On Model E35F, the tether anchor loop is
located behind an access opening underneath the
dinette. Lower dinette table and remove dinette
cushion and bench board to access.
Model E35F
-Typical View
See the child seat manufacturer's specific
instructions for proper attachment and
adjustment of the tether and seat belts.

KEYS

Your motorhome is supplied with several
keys. In addition to the chassis manufacturer's
ignition key, you receive keys for the entrance
door and exterior compartment doors.
Keys have an identification number, either a
1
small metal tag or stamped into the key head.
These numbers are recorded on the vehicle's
component model/serial sheet, which is included
3
in your InfoCase. In case keys are lost or stolen,
your dealer or a locksmith can provide you with
duplicate keys or modify the locks.

PASSENGER WORKSTATION

–If Equipped
Your coach is featured with a passenger in-
dash workstation, for your convenience.
•
DRIVING YOUR MOTORHOME
Grasp handle and flip workstation as shown in
the following photos.
SECTION 3 -
3-5