Step (Entry) - Electric - Winnebago Vista User Manual

SECTION 12 -
MISCELLANEOUS
Remote Operation
• Power
• Timer
• Backlight
Fireplace Remote Control
(Located inside InfoCase)
• POWER: The POWER button supplies
power to all the functions of the fireplace. The
POWER button will put the insert in standby
mode. This will turn off all functions at once
but will hold the settings in the memory. By
pressing the POWER button again the unit
will turn on at the same settings.
• FLAME: Each time the flame button is
pressed, the intensity of the flame decreases.
There are (6) brightness levels you can cycle
through and the OFF setting.
• HEATER: Turns the heater function ON and
OFF.
• TIMER: Press the TIMER button to cycle
through the (10) timer settings (30 minutes, 1
Hour to 9 Hours) and the OFF setting.
• BACKLIGHT: Pressing this button will
change the backlight between the (5) settings:
blue, yellow, blue/yellow, auto, and OFF.
12-6
• Flame
• Heater
Control Panel
NOTE: Holding the POWER button on the
control panel for ten seconds will disable
the heater function.
Further Information
Refer to the Fireplace user guide provided in
your InfoCase for complete operating and
maintenance instructions, as well as safety
precautions.
STEP (ENTRY) – ELECTRIC
–If Equipped
WARNING
Do not use step unless fully extended.
Do NOT stand on step when vehicle
ignition switch is turned to either the "On"
or "Start" position.
The step will automatically retract, which
may cause personal injury.
The power switch for the electric entry step is
located to the left of the main entry door as you
enter the coach.
• Power
• Flame
• Heater
• Timer
• Backlight