Download Print this page

Motorola APX O2 User Manual: Horn (external Alarm) Relay Installation; Lights (external Alarm) Relay Installation; Gunlock Installation; Figure 4-4. Gunlock Switch Redundancy Diagram

Hide thumbs

Advertisement

4-4
4.2.2

Horn (External Alarm) Relay Installation

Mount the horn relay in a suitable location (normally under the dash). Connect the relay contacts
across the horn ring switch, typically found in the steering column. Connect the two control wires to a
SW B+ pin and a VIP OUT pin on the VIP connector.
4.2.3

Lights (External Alarm) Relay Installation

Mount the light relay in a suitable location (normally under the dash). Connect the relay contacts
across the head lamp ON/OFF switch. Connect the two control wires to a SW B+ pin and a VIP OUT
pin on the VIP connector.
4.2.4

Gunlock Installation

The O7 or O9 control head can program up to three gunlocks through the programmable buttons.
You can set the time for the momentary trigger using the time-out trigger button. Connect the relay
contacts across the gunlock switch to install the gunlock. Connect the two control wires to a SW B+
pin and a VIP OUT pin on the VIP connector.
It is recommended to install a failsafe/redundant bypass switch for the gunlock. It is suggested to use
a separate timer switch or a manual push-on button switch to activate the gunlock. Connect the
switch from the supply to the gunlock directly, as shown in
suitable and reachable location, yet not easily seen.
Transceiver
and
control head
GND
Options and Accessories Installation Remote-Mount Accessory Installation
VIP Cable
VIP OUT

Figure 4-4. Gunlock Switch Redundancy Diagram

Figure
4-4. Place the manual button at a
Redundancy
Wiring
Momentary or
time-out bypass
manual switch
Car Battery
GND
Gunlock
GND
6878215A01

Advertisement

   Related Manuals for Motorola APX O2

This manual also for:

Apx o5, Apx o7, Apx o3, Apx o9

Comments to this Manuals

Symbols: 0
Latest comments: