Ubee DVW326 User Manual page 74

Ubee Interactive
Bandwidth
Sideband for Control Channel
(40MHz only)
Control Channel
Regulatory Mode
TPC Mitigation (dB)
OBSS Coexistence
STBC Tx
Apply
Restore Wireless Defaults
Scan Wireless APs
9.1.1 Scanning for Wireless Access Points (APs)
You can search for wireless access points and display the results in a new window.
Steps
To search for wireless access points:
1. Click Scan Wireless APs at the bottom of the Wireless Radio screen. Results are
displayed in a new window.
2. Click Refresh to update the results. Field descriptions are provided below.
Ubee DVW326 Advanced Wireless Voice Gateway Subscriber User Guide • March 2014
Label
Sets the bandwidth to 20Mhz or 40Mhz. For 40 MHz, set the
sideband to lower or upper 20Mhz. 40 MHz channels double
the channel width. This allows doubling the PHY data rate
over a single 20 MHz channel.
Only when using 40MHz Bandwidth should you choose the
Lower or Upper 20MHz.
Set to Auto by default, the Control Channel selects a specific
channel to deploy the wireless network. This allows you to set
the operating frequency/channel depending on your particular
region. Channel selection can have an impact on wireless
networking performance. For more information, refer to
Selecting a Wireless Channel on page 87
Defines whether Regulatory Mode is set to off, 802.11d, or
802.11h.
Defines the transmitter power control (TPC) mitigation setting
as 0 (off), 2,3, or 4.
Enables or disables overlapping BSS coexistence.
Sets the space-time block codes (STBCs) for the transmitting
antenna.
Saves all screen changes when clicked.
Restores the factory default settings for wireless
configurations when clicked.
Scans for other wireless access points and displays channel,
encryption, SSID, RSSI levels, and other information. See the
section below for more information.
Using the Wireless Radio Option
Description
70