Advertisement
Detection range: 10M x 210° ° ° ° (see fig. 3)
Installing your UNIT onto a surface.
1. Place plastic masonry plugs into desired surface aligning holes as shown below. Using an
electric screwdriver, fasten mounting plate directly to surface using screws E.
2. Feed the cable through the back mounting box and bush the cable entry to avoid abrasion to
the cable.
3. Wire the unit as follows: (Ensure all wires are connected securely and that no loose strands
are exposed)
4. Make sure the polarity is correct. Double check the connections after wiring. Mis-wiring may
damage the motion sensor or cause a fire hazard.
5. Place plastic masonry plugs into desired surface aligning holes as shown below. Using an
electric screwdriver, fasten mounting plate directly to surface using screws
Fig. 4
Fig. 3
(See fig. 4 & fig. 5)
Fig. 4
6
Advertisement
