Advertisement
Step 1. Insert/remove Micro SD card (see fig. 1):
When the Surveillance Pro is powered, press the push-button on the bottom of the unit for 3
seconds to stop the light turning before attempting to insert or remove the Micro SD card. To
resume operation, push the push-button again.
Unscrew the waterproofed cover using provided Allen key, and then insert the Micro SD
card until it automatically locks into place.
If you need to remove the Micro SD card, please press OFF/REC button and take it out
within 30 seconds.
When LED light turns green, this means the Micro SD card is being read, do not remove
SD card or data may be lost.
To remove Micro SD card, push in Micro SD card to eject then pull out.
Step 2. Installation
IMPORTANT
IF IN ANY DOUBT ABOUT THE INSTALLATION OF THIS PRODUCT, CONSULT A QUALIFIED ELECTRICIAN
- This product must be grounded
- Do not mount the unit against inflammable surfaces
- The motion detector will not operate correctly if it is installed:
1 Near the outlet of a central heating boiler
2 Near air conditioning plant
3 Pointing directly at moving vehicles
4 Within sight of reflections from moving water
5 Where other lamps could shine on the detector
*BEFORE ATTEMPTING ANY INSTALLATION OR MAINTENANCE, ENSURE THAT THE
ELECTRICAL SUPPLY IS SWITCHED OFF AND THE CIRCUIT FUSES REMOVED OR THE
CIRCUIT BREAKER IS IN THE OFF POSITION.
*Please make sure the voltage and polarity are correct before connection. Incorrect voltage may cause
electric shock. If you are not sure, please contact your retailer.
* DO NOT REMOVE THE TAPE UNTIL YOU FINISH THE INSTALLATION. IF THE TAPE COMES OFF
THE LIGHT, PLEASE REPLAE IT OR HOLD THE LIGHT HEAD TO AVOID SWIVELING AND
DAMAGE THE PRODUCT.
*Note: It is recommend to mount Smart Tracker 2M above the ground for optimum performance, do not
mount the fixture below 1.2M. See below figure for details of performance range.
Fig. 2
LED light
GOOD SENSITIVITY
Micro SD card slot
Fig. 4
TOP VIEW
Fig. 1
LESS SENSITIVITY
5
Advertisement
