Mpeg Select Menu - Motorola DSR4410 Operator's Manual

Press a directional (3456) button to back out of the field and leave it unchanged.
The unit will not be able to decode the chosen virtual channel until a port is setup with
the applicable satellite and polarity information.
Transponder (Xpndr) Field
This non-editable field displays the current transponder name (alpha/numeric) that is
downloaded. The unit will display dashes (---) when no transponder information is
available.

MPEG Select Menu

This menu allows the user to select which service is displayed at the video and audio
outputs by specifying the MPEG program number. Press the56buttons until the MPEG
Select menu appears. The MPEG program number can be used instead of a virtual channel,
but only if the unit is already tuned to the appropriate L-band or ASI input signal.
Program Menu
Press the4button until the cursor is at the Program label, and press the Enter button to
move into the field. While insuring that the cursor remains on the up/down symbol, press
the56buttons to scroll throughout the available MPEG programs. (If the current L-band
or ASI input signal contains four MPEG programs, then only four MPEG programs will
appear in this field.) Press the Enter button to confirm the selection.
This field also provides a second method for selecting the MPEG program: Use
the34buttons to select the digit to change and then, while the cursor is on that digit, press
the56buttons to display the required value. Repeat for each applicable digit.
The unit displays warning messages for the following conditions.
• A warning message is displayed when the user changes from a virtual channel to a
MPEG program number.Press a directional (3456) button to back out of the field
DSR4410
CAUTION: Channel dddd not on RF input
Press E to continue or
MPEG SELECT Program
E ddddd
CAUTION: Changing to MPEG selection mode
Press E to continue or
to stop
to stop
Operating the DSR4410
33