Advertisement
Get parts group B.
10. Install the compressor.
Position the compressor on the bracket,
and install the four 8 x 85 mm flange bolts
(90023-P8A-A00). Torque them to 22 N
11. Adjust the compressor belt tension.
Turn the adjusting
bolt in until the
belt tension
reaches the
"New Belt" tension.
Do not overtighten!
New Belt Tension:
1,030 to 1,130 N
(105 to 115 kg)
NOTE: After the A/C
kit is installed and the
engine has run for
5 or more minutes,
readjust the belt tension
to the "Used Belt" tension.
Used Belt Tension:
490 to 590 N (50 to 60 kg)
2001 American Honda Motor Co., Inc. -- All Rights Reserved
Install the two 10 mm flange
nuts (94050-10080). Torque
.
them to 49 N
m (36 lb-ft).
Install the two 10 x 35 mm
flange bolts (95701-10035-08).
.
Torque them to 49 N
m (36 lb-ft).
.
m (16 lb-ft).
Torque this bolt to
.
44 N
m (36 lb-ft).
AII 22912 (0109)
Clean up the threads
before installing the
compressor bracket.
Position the compressor
bracket over the mounting studs.
.
Torque this nut to 22 N
m (16 lb-ft).
Install the new belt on the crankshaft, alternator,
and compressor pulleys. Make sure the belt is
properly aligned in the grooves of the pulleys.
Fit the belt tension gauge
(T/N 07JGG-001010A) onto the belt.
Do not use any gauge other
than this one!
9 of 16
Advertisement
