Advertisement
15. Install the receiver line, the discharge hose, and the condenser line.
RECEIVER LINE
(Receiver-dryer fitting)
Apply a few drops of
refrigerant oil to the fitting,
then connect the
condenser line to the
receiver-dryer with a
6 x 25 mm flange bolt
(95701-06025-08). Torque
.
the bolt to 10 N
m (7 lb-ft).
Apply a few drops
of refrigerant oil
to the fitting,
then connect the
receiver line to the
receiver-dryer with a
6 x 25 mm flange bolt
(95701-06025-08).
Torque the bolt to
.
10 N
m (7 lb-ft).
Tilt the radiator and condenser back
into place, and install the condenser line.
Apply a few drops of refrigerant oil to the fitting,
then connect the condenser line to the condenser
with a 6 x 25 mm flange bolt (95701-06025-08).
Torque the bolt to 10 N
12 of 16
Slide the receiver-dryer fitting on the receiver
line through the cutout in the bulkhead.
.
m (7 lb-ft).
AII 22912 (0109)
BULKHEAD
CUTOUT
Apply a few drops of refrigerant oil to
this fitting, then connect the receiver
Release this wire
line to the evaporator by moving the
harness clip.
vehicle harness aside. Loosely install
the fitting; do not tighten at this time.
Tilt the radiator and condenser toward the engine,
and install the discharge hose. Apply a few drops of
refrigerant oil to the fitting, then connect the discharge
hose to the condenser with a 6 x 25 mm flange bolt
(95701-06025-08). Torque the bolt to 10 N
2001 American Honda Motor Co., Inc. -- All Rights Reserved
.
Torque the fitting to 13 N
m (9 lb-ft).
Make sure you use a second
wrench to hold the other fitting.
Snap the receiver
line into the clamp.
Install the
receiver line clamp
(80381-SV7-A01).
Install the receiver
line clamp
(80381-SV7-A01)
to the suction
hose bracket
(80363-S84-A00).
Snap the receiver line
into the clamp.
Secure the suction hose
bracket using the 6 mm bolt
removed from the battery
cable holder.
.
m (7 lb-ft).
Advertisement
