Advertisement
12. Reinstall the power steering pump.
Reinstall the power steering pump,
but tighten this bolt only finger-tight.
Install this bolt and
washer finger-tight.
When the belt tension is
correct, torque these bolts
.
to 24 N
m (17 lb-ft), and
recheck the belt tension.
Repeat steps 6 and 7 as
needed to obtain the correct
belt tension.
Get parts group C.
13. Install the receiver-dryer.
Connect this connector
to the pressure switch on
the receiver-dryer.
10 of 16
Reinstall the power
steering pump belt.
Remove the blue tape to free the
pressure switch connector.
Attach the receiver-dryer with a
6 mm flange nut (94050-06080).
.
Torque the nut to 10 N
m (7 lb-ft).
AII 22912 (0109)
Move the breaker
bar until the belt
tension gauge reaches
the proper tension of
390 to 540 N
(40 to 55 kg).
Fit this tension gauge
(T/N 07JGG-001010A)
onto the power steering belt.
Do not use any gauge
other than this one!
1
Insert a
/
" drive breaker bar into
2
the socket on the power steering pump.
2001 American Honda Motor Co., Inc. -- All Rights Reserved
PRESSURE
SWITCH
Advertisement
