Timecode; Hq 1080I - Focus FS-T1001 User Manual

FS-T1001 Menus
•
SP MODE
record mode in the XDCAM EX format.

HQ 1080i

•
- Sets the HQ (35Mb/s) frame size to 1440x1080
1440
•
- Sets the HQ (35Mb/s) frame size to 1920x1080
1920

TIMECODE

•
EXT TC
timecode in the HD-SDI input stream.
•
FREE RUN
constantly incrementing free run timecode generator in the
FS-T1001. It is possible to set the TC value using the TC Set
function in the setup menu.
•
REC-RUN
timecode generator in FS-T1001. Timecode only increments
when a recording is in process. The first frame of a new
recording will have a TC value +1 from the previous recording.
•
REGEN
timecode generator on FS-T1001. Timecode only increments
when a recording is in process. The first frame of a new
recording will have a TC value +1 from the last recording on
the media.
FREE RUN
RP-188 timecode in the incoming HD-SDI stream. These
modes are useful when the RP-188 timecode in the HD-SDI
stream is not desired or the source does not support RP-188
timecode.
22 - FS-T1001 Media Recorder
- Sets the record bit rate to 25Mb/s (MP@H-14)
HD SDI Input for SP Mode
See the supported frame rates in the specification section of
this manual.
Record Modes
For both record modes the standard (50/60Hz) and the frame
rate will follow that of the source. It is not possible for frame
rate conversion, standards conversion, scaling or
interlacing/deinterlacing.
- The recorded timecode comes from the RP188
- The timecode recorded comes from the internal,
- The timecode recorded comes from the internal
- The timecode recorded comes from the internal
, and
REC-RUN
record modes ignore the
REGEN