Advertisement
SPARE PARTS LIST FCS-180
REF.NR.
DESCRIPTION
007
SWITCH
014
PINION GEAR
017
ROTOR
019
STATOR
021
PCB
022 TILL 034
DRIVE MECHANISM COMPLETE
025
SPINDLE GEAR
037
ELASTIC PILLAR
038
ELASTIC PILLAR
044
DELTA SANDING PAD
045
ROTARY SANDING PAD
046
SCRAPER
048
BASE FOR SCRAPER AND CONTOUR SANDER
051 TILL 054
CARBON BRUSH SET COMPLETE
055
U-SHAPE CONTOUR SANDER
056
Y--SHAPE CONTOUR SANDER
10
OPERATIONAL SAFETY
Warning! Be aware this sander can produce fine dust,
FERM NR.
which can be hazardous to your health.
Some older painted surfaces may contain harmful lead – clean the
301120
area and tool thoroughly after sanding.
301121
Always use a suitable mask, eye protection, gloves and use dust
301122
extraction during sanding and cleaning.
Keep children and pregnant women well away from work area.
301123
Do not eat, drink or smoke while working or in the work area.
301124
Concentrate
301125
Routine and repetition can lead to mistakes. Remember
301126
that a slight lack of concentration can result in serious
301127
injuries in a split second.
301128
Keep work area clean
301129
Cluttered areas and benches invite injuries.
301130
Consider the work environment
301131
Do not expose power tools to rain or use them in damp
301132
or wet locations. Keep work area well lit. Do not use
power tools in the presence of flammable liquids, vap-
301133
ours or gases.
301134
301135
Guard against electric shock
This unit contains dangerous voltages. Use a RCD (resi-
dual current device) to provide protection against elec-
trical shock. Prevent body contact with grounded sur-
faces (e.g. pipes, radiator, ranges or refrigerators).
Keep children and pets away
Do not let children or pets come into contact with the
tool, extension cable or work area.
Do not force the tool
It will work better and safer at the rate for which it was
intended.
Use the right tool
Do not force small tools or attachments to do the job of a
heavy-duty tool. Do not use tools for purposes for which
they were not intended; for example do not use a circular
saw for cutting trees or logs.
Do not abuse the cable
Never carry the tool by the cable or pull it to disconnect
it from the power socket. Keep the cable away from heat,
oil and sharp edges. Do not touch the metal plug pins
when connecting or removing the plug.
Do not over-reach
Keep a proper footing and balance at all times.
Disconnect tools from power supply
When not in use, before servicing and when changing
accessories such as blades, bits and cutters.
Always switch off and unplug the sander from the
power supply before making adjustments or chan-
ging abrasive sheets
Remove adjusting keys and wrenches
Ensure that they are removed from the tool before swit-
ching on.
Ferm
Ferm
Avoid unintentional starting
Do not carry plugged in tools with your finger on the
switch. Check that the switch is off before plugging in to
socket.
Outdoor use extension cables
When the tool is used outdoors use only an extension
cable intended for outdoor use and marked accordingly.
Use a RCD (residual current device) to provide protec-
tion against electrical shock. Do not use in rain or damp
conditions.
Connect a dust extraction device
Whenever there are facilities for fitting a dust or fume
extraction system, make sure it is connected and used.
Use recommended accessories
The use of any other accessory or attachment other than
recommended in the instructions or catalogue may pre-
sent a risk of personal injury. Avoid the use of long exten-
sion cables.
3
Advertisement
