Simple Configuration
How to Configure Global Parameters
There are some parameters that can be set that will affect the overall system;
video standard for the video inputs, browser format for the web interface,
language that the menus will be displayed in and the DST (daylight saving time)
settings.
To configure these parameters:
1. Select Home -> Main Set-up.
2. Select the video standard from the drop down list; this will be the standard for all the video
inputs on the Digital Sprite 2.
Note: If the video format is changed it is necessary to carry out a system reset
before saving the settings. This allows the unit to activate the change.
3. Select the date format from the drop down list.
4. The Digital Sprite 2 web pages can be viewed in two formats; Active X (default) or Java,
select the relevant option from the drop down list.
5. The web configuration pages for the Digital Sprite 2 can be displayed in a selection of
languages, select the language which is most appropriate to your installation from the drop
down list.
Note: Ensure the PC being used for the configuration is set to the correct time zone
and that DST is enabled before continuing.
6. Select the DST for region where the unit is installed from the drop down list.
7. If the settings are incorrect reset the Digital sprite 2 by selecting the reset button.
8. If the Digital Sprite 2 time is to be synchronised to the PC that is being used to configure the
system then select sync unit time from PC. Note this only synchronises the time when the
button is selected this will not maintain synchronisation permanently.
9. Remember to save the configuration by selecting Save Settings!
Dedicated Micros
Page 7
Need help?
Do you have a question about the Digital Sprite 2 and is the answer not in the manual?