Network Configuration Of The Digital Sprite 2; Web Page Icons - Dedicated Micros Digital Sprite 2 Manual

Network Configuration of the Digital Sprite 2

This manual covers the advanced configuration of the Digital Sprite 2 via the on-board web
pages plus the OSD menus that cover network functionality.
To assist you with the configuration of the Digital Sprite 2, this section is constructed in a tutorial
manner and will make use of typical scenarios describing how to ........ allocate an IP address,
set up VMD, etc. Select the sections that are relevant to the functionality required for your
application and follow the step by step instructions. In some of the sections the web interface
and the OSD menus will be displayed, these are the more advanced network settings where
configuration via the web pages is more appropriate.
As with the Installation of the unit this section will be divided into:
Simple Configuration – required to get the unit up and running
Advanced Configuration – project specific requirements
Note: It is presumed that the main configuration steps detailed in the Digital Sprite 2
Setup Guide have been followed and therefore the cameras inputs have been
enabled and the standard record rate has been set, although these features are also
detailed within this section.

Web Page Icons

Each of the Digital Sprite 2 configuration web pages has the following buttons:
Reset to Defaults – this will return the associated page to factory defaults.
Display Help – this will display the Help pages for the associated configuration page.
This is a good starting point if you are having problems or do not understand the
configuration parameters.
Save Settings – this will save a changes that has been made to the configuration page -
remember to save the changes selecting a new page before saving the changes will
result in all changes will be lost!
Reset – this will be displayed on the configuration pages for functionality that requires
the unit to be reset to initiate the function, always save the settings before resetting the
unit.
For each How to.... section the Tab name and Function name will be shown allowing you to
easily locate the correct configuration page.
Page 4 Dedicated Micros