Dedicated Micros Digital Sprite 2 Manual page 41

Note: Any configuration carried out at this stage is for the selected video input and
zone, you will need to save the settings and then select another zone to configure the
whole area.
15. Alternatively if the default zones are not positioned over the areas you intend assign for
detecting motion detection there is an option to clear all cells, you will be presented with a
prompt to check you want them cells deleting, select Yes.
16. To set a zone click at the edge of the area where you want to place the zone, move to the
opposite corner where the zone will sit and click again, a zone area will be displayed over the
area.
17. It is possible to have a grid overlay displayed on the image to assist in placing the zone
areas, select graticule on to display the grid.
18. Select the next zone from the drop down box to create another zone area and follow Step
16.
Note: If this is incorrect then you can click again and the zone will move to the new
area.
Dedicated Micros Page 39