Changes Via Rotary Switches After Installation Of The Quick Module - SMA SUNNY BOY 2000HF Installation Manual

SMA Solar Technology AG
5.4.1 Changes via rotary switches after installation of the
Quick Module
If you have already connected the Quick Module to the inverter and would like for example to
configure the installation country or the display language via the rotary switches, then proceed as
follows:
1. Disconnect the inverter on the AC and DC sides as described in section 8 "Disconnect the
Inverter from Voltage Sources" (page 60).
2. Pull the Quick Module out to the first stopper.
3. Flip the flap up and pen the lid until it locks in place.
4. See section 5.3.4 "Setting the Country Standard and Language using Rotary Switches"
(page 29) for setting the installation country and the display language.
5. See section 5.3.5 "Communication via Bluetooth" (page 30) for assigning the NetID via
Bluetooth.
6. Close the lid of the Quick Module and flip the flap
down again until it locks into place.
Installation Guide
The communication module (Quick Module)
SB20_25_30HF-IEN102911 33