General Maintenance - Electrolux CXl09HL1W User Manual

22 www.electroluxaircomfort.com
3. Carefully lift the dust box up, then pull it out
of the frame of the Dust Collector.
4. Put the dust box into the warm water with
a small amount of neutral detergent for ten
minutes or longer, then clean it with a soft
brush. Rinse with clean water after make
sure the box is clean, dry it completely, then
install back to the frame of dust collector.
5. Make sure the dust box is correctly fi xed into
the frame and the two clips of dust box are
securely fi xed in place.
6. Put the fi lters back and install the front panel.
Warning
• When cleaning the unit, fi rstly make sure that
the power and circuit breaker are turned off
for at least 60 seconds.
• Do not use high pressure air to blow plasma
dust collector so as to avoid accidental injury
and damage to the eyes and the collector.
• Do not expose the collector directly under
the sunshine or put it close to the fi re, which
may cause deformation and damage.
• Be careful not to break the tungsten fi lament
during the operation, and avoid vigorously
scrubbing the dust collector.
• Do not use strong corrosive detergents to
clean the dust collector.
• Ensure the dust collector is completely dried
before install it back to the indoor unit to
avoid electricity leakage.
Cleaning the Cold Plasma Generator
Do not touch or try to clean the Cold Plasma
Generator by yourself, and it may cause electric
shock.
Please contact qualifi ed personnel or Electrolux
service centre for clean or replacement if
necessary.

General Maintenance

If the air conditioner is not going to be used for a
long period of time:
• Operate in FAN only mode for 1~2 hours to
allow the unit to completely dry out.
• Switch off the unit and pull out the power
plug. Remove the batteries from the remote
control.
• The outdoor unit requires periodic
maintenance and cleaning. Do not attempt
to do this yourself. Contact your dealer or
service technician.
Checks before operation
• Check that the wiring is not broken or
disconnected
• Check that the dust fi lter is installed.
• Check if the air outlet or inlet is blocked if the
air conditioner has not been used for a long
time
Warning
• Do not touch the metal parts of the unit
when removing the fi lter. Injuries can occur
when handling sharp metal edges.
• Do not use water to clean inside the air
conditioner. Exposure to water can destroy
the insulation, leading to possible electric
shock.
• When cleaning the unit, fi rst make sure that
the power and circuit breaker are turned off.