How To Use; Edge Cleaning; Attach Tools; Rug And Floor Nozzle - Hoover vacuum cleaner Owner's Manual

1. HOW TO USE

Rug and Floor Nozzle

The combination rug and floor nozzle has been designed to do an efficient job on both carpet and hard
surface floors.
Hard Surface Floors
1.1
Lower brushes to clean bare floors by sliding
indicator to BARE FLOOR.

Edge Cleaning

This feature provides for improved cleaning of
carpet edges near baseboards and solid furniture.
Passages have been added to the side of the
nozzle to increase air flow carrying dust down
from the carpet edge to the nozzle.

Attach Tools

1.3 1.4
Attach tools to end of hose by rotating plastic
latch ring until slots align; insert tool and rotate
latch ring to lock.
To remove tool, reverse above procedure.
Attach tool to either extension wand by pushing
button projection end of tool into spring latch
of wand. Latch will snap into place when locked
together.
To disconnect, press down on the center of the
spring latch and remove tool.
Rugs
1.2
Raise brushes to clean rugs or carpet by sliding
indicator to RUG.
For most efficient cleaning, place the nozzle flat
on rugs and hard surface floors.
Clean Stairs
Place cleaner on
1.5
stair.
Clean stairs from
bottom to top.
Blower
1.6
1.7
Used to blow dirt out Pull up louvered door
of areas where it is at back of cleaner and
impossible for suction insert hose connector
to reach. into corresponding
slots in opening.
To use blower, turn
hose connector as Turn hose connector in
shown and remove either direction until it
hose from bag door. locks into place.
4
French