KVH Industries TracVision HD7 Installation Manual page 14

7
Continued
Connect Additional RF Cables - Non-SWM
Receivers/DVRs Only
Follow the instructions below if you need to
connect non-SWM receivers/DVRs. Non-SWM
receivers/DVRs include DIRECTV Latin
America, DISH Network, Bell TV, and legacy
DIRECTV receivers. SWM-compatible receivers/
DVRs are listed below.
• HR20
• HR21
• HR21 Pro
• HR22
• HR23
• H20
• H21
NOTE: Additional SWM-compatible receivers/DVRs
might become available at any time. If your receiver or
DVR model is not listed here, check the receiver's/
DVR's manual to see if it is SWM-compatible.
a. Connect RF cables to the antenna's RF2 and
RF3 connectors (see
7/16" open-end wrench, tighten the RF cables
for 1/4 turn.
b. Label the ends of the SWM (RF1), RF2, and
RF3 cables for easy identification later.
c. Seal the RF cable connections with silicone
sealant, self-vulcanizing tape, or equivalent.
d. Route the cables belowdecks through the
cable access hole. Leave an adequate service
loop, approximately 8" (20 cm) of slack, in the
cables for easy serviceability.
10
Wire the Antenna
• H22
• H23
• R16
• R22
• R23
• D12
• D13
Figure 12). Then, using a
Figure 12 Antenna Connectors
POWER
SWM
(RF1)
TO SWM
Power
Inserter
RF2
DATA
Non-SWM
Receivers
RF3
(DIRECTV Latin
America, DISH
Network, Bell TV,
and Legacy
DIRECTV
Receivers)
RF4