Connect The Acu To The Network - KVH Industries TracVision HD7 Installation Manual

Connect the ACU to the Network

13
This section details the ACU's default network
settings, other available options, and methods for
changing settings. When the TracVision system is
connected to the vessel's onboard network, or
you connect to the TracVision HD7 system using
an ad-hoc WiFi connection, the following
features are enabled:
• Remote operation of the TracVision HD7
system
• Remote viewing of the system's status,
including current satellite signal levels,
satellite settings, and other system
information
NOTE: When setting up a wireless network, be sure
to apply security settings, such as encryption, to
protect your network from outside intrusion. If your
network is not secure, outsiders within range of your
wireless network will be able to use your wireless
connection without your knowledge.
TIP: The ACU is Bonjour
connected to the vessel's onboard network, you can use
Bonjour to easily connect to the ACU using a PC on
the same network, without requiring the IP address.
The ACU is displayed in Bonjour as: hd7-<ACU
serial number>. For more information, visit
www.apple.com/support/bonjour.
18
®
-enabled. Once the ACU is
Figure 30 Connection Options
WiFi Antenna
ANTENNA
ETHERNET
FUSE AC INPUT
100-240V~
3.15A
160W MAX
250V~
FAST ACTING 50/60 HZ
This device complies with Part 15 of the FCC rules. Operation is subject
CAUTION to the following two conditions: (1) This device must not cause harmful
RISK OF ELECTRIC SHOCK interence, and (2) This device must accept any interference received,
including interference that may cause undesired operation.
DO NOT OPEN
ETHERNET
- Optional
RS232
Tested to comply
with FCC Standards Wi-Fi
Meets requirements
KVH and TracVision are registered
trademarks of KVH Industries, Inc.