Remove The Restraints - KVH Industries TracVision HD7 Installation Manual

6

Remove the Restraints

Internal restraints prevent the antenna assembly
from moving during shipment. Follow these
steps to remove these shipping restraints.
NOTE: Be sure to keep the shipping restraint
hardware for future use.
a. Using a #2 Phillips screwdriver, remove the
six #10-32 Phillips screws securing the
radome to the baseplate (see
b. Carefully lift the radome straight up off the
antenna. Then set it aside in a safe place.
c. Using a 9/16" nut driver or wrench, remove
the four bolts, two brackets, and two washers
securing the antenna to the shipping pallet
(see Figure 10).
TIP: You will remove additional shipping restraints
after you mount the antenna.
8
Figure 9 Radome Screws
Radome
Screw (x6)
Figure 9).
Baseplate
Figure 10 Shipping Restraints
Bracket
and Bolt (x2)
Bolt and
Washer (x2)