Chevrolet 2007 Corvette Owner's Manual page 248

If your vehicle has the Bose
®
includes Bose AudioPilot
technology. When turned on, AudioPilot
continuously adjusts the audio system to
compensate for background noise, so that the
music always sounds the same at the set volume
level. This feature is most effective at lower radio
volume settings where background noise can affect
how well you hear the music being played. At
higher volume settings, where the music is much
louder than the background noise, there could be
little or no adjustments by AudioPilot
®
To use AudioPilot , set the radio volume to your
desired level. Turn AudioPilot
automatic volume button until AVOL ON displays.
As the vehicle goes faster, the background noise
®
increases. AudioPilot
sound level to overcome background noise. To turn
®
AudioPilot off, press the automatic volume button
until AVOL OFF displays. For additional information
®
on AudioPilot , visit www.bose.com/audiopilot.
MUTE: Press this button to silence the system.
Press this button again to turn the sound on.
This button is not available on the Radio
with Six-Disc CD.
248
®
audio system, it
®
noise compensation
®
®
.
®
on by pressing the
adjusts the audio system's
Finding a Station
BAND: Press this button to switch between FM1,
FM2, AM, or XM1 or XM2 (if equipped). The display
shows the selection.
O
/ (Tune): Turn the
e
radio stations.
t u
SEEK : Press the left
arrow to go to the previous or to the next station
and stay there.
The radio only seeks stations with a strong signal
that are in the selected band.
t u
SCAN : Press and hold either the left
u
right SCAN arrow for two seconds until
FREQUENCY SCAN displays. The radio goes to a
station, plays for a few seconds, then goes on to the
next station. Press either the left
SCAN arrow again to stop scanning.
To scan preset stations, press and hold either the
t u
left or right SCAN arrow for four seconds until
PRESET SCAN displays. The radio goes to the
next preset station, plays for a few seconds, then
goes to the next preset station.
O
/ knob to select
e
t u
or right SEEK
t
or
t u
or right