Assemble The Voice Case - Honeywell MX8 User Manual

Assemble the Voice Case

The voice case is a sturdy, lightweight, protective covering for the MX8. The voice case cannot protect the MX8 from
destructive, excessive force or a harsh or wet environment. It is designed to protect the MX8 from dirt, dampness, and minor,
trivial bumps or jostling. The MX8 battery cannot be hotswapped while the MX8 is enclosed by the voice case.
Voice Case Front
1. Open the belt loop on the voice case. The belt loop snaps are self locking at the dimple. Locate the dimple on each belt
loop snap. Unfasten each belt loop snap by using your thumb to push the snap head upward at the dimple.
2. Place the belt on the voice case inside the open area of the belt loop. Fasten the belt to the voice case. Lock each belt
loop snap by rocking the snap head onto the snap base (starting on the opposite side of the dimple) and pressing down
on the dimple side of the snap head.
3. Do not put the belt on yet.
4. Attach the audio adapter/cable to the base of the MX8. Do not connect the headset to the cable yet.
5. Slip the MX8 into the voice case, with the keypad and touch screen facing the front of the case. The audio cable should
be exiting the side opening at the left side of the case. If it is not, remove the MX8 from the voice case, turn it around and
insert into the voice case again.
6. Close the voice case cover by folding the hook side over the loop side. Press along the length of the cover until the hook
and loop fabric is secure.
2-20
Belt Loop Snaps