Storage; Cleaning And Disinfecting; Maintain; Transportation And Storage - Contec CMS60C User Manual

thiosalicylic hemoglobin, and some with icterus problem, the SpO
may be inaccurate.
C C C C . . . .
The drugs like dopamine, procaine, prilocaine, lidocaine and butacaine may also be a major
factor blamed for serious error of SpO
D D D D . . . . As the SpO
value serves as a reference value for judgement of anemic anoxia and toxic anoxia,
2
some patients with serious anemia may also report good SpO
7 7 7 7 M M M M aintain aintain transportation
aintain、transportation aintain transportation and transportation
7.1 Cleaning 7.1 7.1 7.1 Cleaning Cleaning and Cleaning and and and Disinfecting Disinfecting Disinfecting Disinfecting
Using medical alcohol to disinfect the device, nature dry or clean it with clean soft cloth.
7.2 7.2 7.2

7.2 Maintain

Maintain Maintain Maintain
A. A. A. A. Please clean and disinfect the device before using according to the User Manual(7.1).
B. B. B. B. Please recharge the battery when the screen shows
C. C. C. C. Recharge the battery soon after the over-discharge. The device should be recharged every six
months when it is no regular used. It can extend the battery life following this guidance.
D. D. D. D. Please take out the batteries if the oximeter is not in use for a long time.
E. E. E. E. The device needs to be calibrated once a year (or according to the calibrating program of
hospital). It also can be performed at the state-appointed agent or just contact us for calibration.
7.3 7.3 Transportation Transportation and and
7.3 7.3 Transportation Transportation and
A. A. A. A. The packed device can be transported by ordinary conveyance or according to transport contract.
The device can not be transported mixed with toxic, harmful, corrosive material.
B. B. B. B. The packed device should be stored in room with no corrosive gases and good ventilation.
Temperature: -40°C~60°C; Humidity: ≤95%
8 8 8 8 Troubleshooting Troubleshooting
Troubleshooting Troubleshooting
Trouble Trouble Trouble Trouble
The The The The SpO SpO SpO SpO and and and and Pulse Pulse Pulse Pulse
2 2 2 2
Rate Rate can Rate Rate can can not can not not be be be be not
displayed normally
displayed displayed displayed normally normally normally
The The SpO SpO and and Pulse Pulse
The The SpO SpO and and Pulse Pulse
2 2 2 2
Rate Rate are are not not
Rate Rate are are not not
display display ed ed ed stabl stabl stably y y y stabl
displayed display
The The device device can can not not
The device The device can can not not
be be be be turn turn turned turn ed ed ed on on on on
measure.
2
and

storage

and and storage storage storage
storage storage
and storage storage
Possible Possible Possible Possible Reason
1. The finger is not properly positioned.
2. The patient's SpO
detected.
1. The finger is not placed inside deep
enough.
2. The finger is shaking or the patient is
moving.
1. The battery is drained away or almost
drained away.
2. The battery is installed incorrectly.
3. The malfunction of the device.
measurement.
2
.
Reason Reason Reason
is too low to be
2
12
determination by this monitor
2
Solution Solution Solution Solution
1. Place the finger properly and
try again.
2. Try again; Go to a hospital for
a diagnosis if you are sure the
device works all right.
1. Place the finger properly and
try again.
2. Let the patient keep calm
1. Please recharge the battery
2. Please Install the
again.
3. Please contact the local service
center.
battery