Setup; Basic Setup And Connections; Setup Basic Setup And Connections - PRG Mbox User Manual

SETUP

Basic Setup and Connections

To interconnect the case components:
Step 1. Remove front and back covers from case (Figure 2-4).
Step 2. Remove keyboard and trackball from case.
Step 3. At rear of case, verify that Monitor (2), USB (3), Ethernet (2), Video In (2) and Power cables are connected to
computer.
1
Remove covers
3
Verify rear connections
ETHERNET LEFT RIGHT
BALANCED AUDIO OUT
SITE WIR ING
FAULT
SENSIBILITY
Monitor, USB, and Ethernet Connections
(permanently connected - do not alter)
Step 4. At front of Dual I/O module, connect local monitor data cable to DVI connector labeled "Preview."
Step 5. Connect local monitor power cable to UPS or to local AC power service.
Step 6. Connect UPS power cable to local AC power service.
Step 7. Connect stage outputs and other Mbox Extreme servers (if required) according to the following sections.
Auxiliary Input
SMPTE IN
MIDI IN MIDI OUT SDI IN Y IN R - Y IN B - Y IN
Connections
(COMPOSITE)
US B PORT
OVERLOAD
PROTECTOR
INPUT
PUSH TO
RE SET
OUTPU T: 120V 50/60 Hz
To AC Power
Figure 2-4: Removing Covers and Components
2
Remove components
4
Connect monitor and power source
Connect monitor
AC cable to UPS
or local AC
To AC Power
®
MBOX MEDIA SERVER USER MANUAL
Connect monitor
data cable to DVI
Preview
25