Table of Contents
Advertisement
HARDWARE SETUP
Basic Setup and Connections
To interconnect the case components:
Step 1.
Remove front and back covers from case.
Step 2.
Remove keyboard and trackball from case.
➊
Remove covers
Step 3.
At rear of case, verify that DVI (2), USB (3), Ethernet (1), Video In (4), Thunderbolt (1), Video Sync (1), and IEC
power cables (3) are connected to the Sonnet xMac unit's rear panel.
➌
Verify rear connections
AC IN
100 -240 V AC
50 / 60 Hz
1A MAX
SITE WIRING
FAULT
100-240V. 50-60Hz
Step 4.
At front of Dual I/O Module, connect local monitor data cables to DVI Preview connectors.
Step 5.
Connect local monitor power cables to UPS or to local AC power service.
Step 6.
Connect UPS power cable to local AC power service.
Step 7.
Connect video output Stage connectors according to the following sections.
US B 1
DV I IN 1
V IDE O S Y NC 1
E T HE R NE T A
E T HE R NE T B
US B 2
DV I IN 2
V IDE O S Y NC 2
USB PORT
PROTECTOR
INPUT
PUSH TO
RESET
SENSIBILITY
OUTP
0V 50/60 Hz
R IG HT
LE F T
LINE OUT P UT S
R IG HT
LE F T
USB
4
3
2
1
DV I 1
DV I 2
1
E NE T A
HDMI
E NE T B
2
SDI 4
SDI 3
SDI 2
SDI 1
3
➋
Remove keyboard and trackball
➍
Connect monitors and power
MBOX® 2016 DUAL OUTPUT HARDWARE MANUAL
11
Advertisement
Table of Contents
