Chefman My Barista RJ30 SERIES User Manual page 15

Cleaning and Maintenance (cont'd)
STEP 2: RINSE
Step 1: Ensure the Water Tank is filled with fresh water.
Step 2: Place a large mug on the Drip Tray.
Step 3: Press and release the Power Button, and wait until the Brew Buttons stop flashing.
Step 4: Run a brew cycle. DO NOT USE A PORTION PACK OR COFFEE GROUNDS, just
press the LARGE (10 OZ.) Brew Button. Once the Brewer has finished dispensing
pour the contents of the large mug into the sink.
Step 5: Repeat the brew process without a portion pack or coffee grounds until the
Power and Brew Buttons begin to flash.
Step 6: You may need to perform additional Rinse cycles if you notice any residual
taste.
SERVICE
Beyond these recommended cleaning and maintenance procedures this Brewer is
not user serviceable. For service, please refer to the Warranty section of this guide.
STORAGE
Empty the Water Tank before storing, and take care to ensure that you store your
Brewer in a safe and frost free environment. Please be sure to store your Brewer
in its upright position to avoid water leakage from the inner tank. If you store the
Brewer in a cold environment, you run the risk of water freezing inside the Brewer
and causing damage. When you prepare to use it after storage, we recommend
rinsing the Water Tank with fresh water and running three cleansing brews
without a portion pack or coffee grounds.
If you plan to move your Brewer to a different location, turn the Brewer off, unplug
it, and empty the Water Tank. If your Brewer has been in an environment below
freezing, please be sure to let it warm to room temperature for at least 2 hours
before using.
Transport Brewer in the upright position to ensure inner tank does not leak
through vent.
12
AFTER SALES SUPPORT
888-315-8407 customerwarranty@rjbrands.com MODEL: RJ30 SERIES
USA