Operating Instructions - Chefman My Barista RJ30 SERIES User Manual

Operating Instructions

SET-UP & FIRST BREW
IMPORTANT: Before using your Chefman® My Barista™ Brewer please follow the
instructions below. The Brewer will not function properly unless these steps are
followed.
NOTE: If Brewer has been exposed to temperatures below freezing, allow Brewer at
least two hours to reach room temperature before brewing. A frozen or extremely
cold Brewer will not operate.
SETTING UP YOUR BREWER
1A
Figure 1A & 1B
1. Unwrap cord and plug the Brewer into a grounded outlet. Remove all pieces of
packing tape and plastic stickers.
2. Place a mug (10 oz. minimum) on the Drip Tray.
3. Remove the Water Tank from Brewer by firmly grabbing the tank, then lifting the
Water Tank straight up. Rinse with fresh water.
4. Fill Water Tank with bottled or filtered water so that the water level does not
exceed the "MAX" fill line (fig. 1A).
5. Place Water Tank base into the back of the Brewer and be sure the Water Tank is
securely in place. (fig. 1B)
6. Simultaneously press the small and large Brew Buttons for 1 second (fig. 2),
then release. Both small and large Brew Buttons will now flash alternately while
water comes out from the Spout.
7. Press and release the Power Button, and wait until the Brew Buttons stop
flashing. (fig. 3)
Your Chefman® My Barista™ is now ready to use.
AFTER SALES SUPPORT
1B
8 oz.
Figure 2
888-315-8407 customerwarranty@rjbrands.com
USA
10 oz.
8 oz.
Figure 3
7
10 oz.
MODEL: RJ30 SERIES