Cleaning And Maintenance - Chefman My Barista RJ30 SERIES User Manual

Cleaning and Maintenance

Regular cleaning of the Brewer's external components is recommended.
1. Never immerse the Brewer in water or other liquids. The housing and other
external components may be cleaned with a soapy, damp, non-abrasive cloth.
2. The Drip Tray can accumulate up to 5 ounces of overflow. The Drip Tray and Drip
Tray Plate should be periodically inspected and rinsed clean.
pack above the cartridge and in the bottom of the cartridge. To avoid risk of injury,
do not put your fingers in the cartridge.
CLEANING THE SPOUT
Should a clog arise due to coffee grinds, it can be cleaned using a paper clip or
similar tool. Remove cartridge, insert the paper clip into the Spout to loosen the
clog and push it out.
AFTER SALES SUPPORT
REMOVING THE DRIP TRAY ASSEMBLY
Slightly lift tray while keeping it leveled at all times to avoid spilling.
The Drip Tray and Drip Tray Plate may be placed in the dishwasher.
They may also be cleaned with a damp, soapy, non-abrasive cloth
and rinsed thoroughly.
CLEANING THE CARTRIDGE
The cartridge can be placed onto the top shelf of a dishwasher.
NOTE: Use low temperature cycles in the dishwasher. To remove
from the Brewer, open the Brewer Head by lifting the Latch.
Grasp the top of the cartridge with one hand, pull upward until it
releases. After cleaning, simply insert the cartridge back into the
compartment, be sure the cartridge is firmly in place.
CLEANING THE EXIT NEEDLE
The exit needle is located on the inside bottom of the cartridge.
Should a clog arise due to coffee grinds, it can be cleaned using a
paper clip or similar tool. Remove cartridge, insert the paper clip (as
shown left) into the needle to loosen the clog and push it out.
CAUTION: There are sharp needles that puncture the portion
10
888-315-8407 customerwarranty@rjbrands.com
USA
MODEL: RJ30 SERIES