D-Link DVX-2004 User Manual page 11

Item
Search
Show all
Name
Extension
Password
Outbound CID
VM Password
E-mail
Dial Plan
Analog Phone
Voicemail
Can reinvite
SIP
IAX2
T.38 Fax
Agent
NAT
Pickup Group
Delete VMail
DTMF Mode
Video Call
Permit IP
Auto Provision
Codecs Configure
Search extension precisely or fuzzily
Show all extensions
Extension name (English letter is supported only) eg: "Tom"
Be connected to the phone eg: "888"
Password of SIP/IAX2 extension eg: "12u3b6"
Overrides the caller id when dialing out with a trunk.
Voicemail Password for this user, eg: "1234".
The e-mail address for this user, eg. "Tom@gmail.com"
Please choose the Dial Plan for this user，Dial Plan is defined
under the "Outbound Routes".
If this user is attached to an analog port on the system, please
choose the port number here.
This user will have a voicemail account after choosing this option.
Set up calls directly between caller and receiver, after being
connected by IP PBX system. This method is known to cause
problems with certain hardware, such as the common Cisco ATA
186.
Check this option if the User or Phone is using SIP or is a SIP
device.
Check this option if the User or Phone is using IAX2 or is an IAX2
device.
Enables T.38 fax (UDPTL) pass through on SIP to SIP calls
Check this option if this User or Phone is an Call Agent.
Check this option if the User or Phone is located behind a NAT
(Network Address Translation) enabled gateway.
Select your pickup group.
Voicemail will not be checkable by phone if you choose this option.
Messages will be sent by email only.
Note: You must configure SMTP server for this functionality.
The Dual-Tone Multi-Frequency mode to be used is specified here
and can be changed if necessary. The default is rfc2833.
Enable/Disable Video call for this extension
IP address and network restriction.
eg: "192.168.1.77" or "192.168.10.0/255.255.255.0"
Enter the MAC address of the specified extension, the system will
automatically create the config file accordingly. (Just support
DPH150 and DPH400 IP Phone)
The allowed and disallowed codecs can be selected by clicking this
link. Default codecs are alaw, ulaw and G.729.
Explanation
10