Other Manuals and Information Sources for Your Machine
• Instructions for Use (English, Spanish and French) – Form Number 56091061
• Parts List – Form Number 56042598
These manuals can be found on the following Clarke electronic supported databases:
• Clarke website:
www.clarkeus.com
• Clarke CustomerZone
• EzParts service / parts CD-ROM
Cautions and Warning Symbols
Clarke uses the symbols below to signal potentially dangerous conditions. Read this information carefully and take the
necessary steps to protect personnel and property.
Danger!
Is used to warn of immediate hazards that will cause severe personal injury or death.
Warning!
Is used to call attention to a situation that could cause severe personal injury.
Caution!
Is used to call attention to a situation that could cause minor personal injury or damage to the machine or other property.
Read all instructions before using.
General Safety Instructions
Specific Cautions and Warnings are included to warn you of potential danger of machine damage or bodily harm.
Warning!
• This machine should only be used by properly trained and authorized persons.
• While on ramps or inclines, avoid sudden stops when loaded. Avoid abrupt sharp turns. Use low speed down hills.
Clean only while ascending (driving up) the ramp.
• Keep sparks, flame and smoking materials away from batteries. Explosive gases are vented during normal
operation.
• Charging the batteries produces highly explosive hydrogen gas. Charge batteries only in well-ventilated areas away
from open flame. Do not smoke while charging the batteries.
• Remove all jewelry when working near electrical components.
• Turn the Key Switch off (O) and disconnect the batteries before servicing electrical components.
• Never work under a machine without safety blocks or stands to support the machine.
™
Form No. 56043161 - Clean Track
L24 - 7
®