Scrub Brush Deck Removal - Clarke Clean Track® L24 56317170 Service Manual

Scrub Brush Deck Removal

1. Turn the Key Switch on and lower the scrub deck.
2. Lift up and remove the cover and nose cone from the front of the machine.
3. Disconnect the electrical connector from the deck actuator motor to prevent the deck from rising once the Key
Switch is turned off.
4. Turn the Key Switch off and disconnect the battery pack.
5. Remove the debris hopper from the scrub deck.
6. Disconnect and remove the detergent cartridge from the machine.
7. Remove the Nozzle Cover.
8. Disconnect the green and yellow ground wire from the left-hand scrub motor.
9. Disconnect the solution system water lines from the nozzle fittings. Use a cup or other receptacle to catch any
solution remaining in the lines.
10. Unplug both of the brush motor wiring harnesses. Note that you may need to cut cable ties to do this.
11. Remove the Cotter Hair Pin and Ring Hitch Pin holding
the Actuator Yoke to the actuator bracket weldment.
Note: Carefully lift up on the scrub deck if
necessary to take pressure off of the Ring
Hitch Pin.
12. Remove the Cotter Hair Pin from one side of the
Actuator Pin, then remove the Actuator Pin and the
two Spacers from the deck weldment and Actuator
Tube.
Service Tip: It is important that the actuator
motor is not run or the actuator is
not rotated while it is disconnected
from the deck or chassis mounts.
This precaution will prevent the
actuator drive nut from getting out
of adjustment (moved out of its set
specification).
Ring
Hitch Pin
Actuator
Yoke
Spacer (2)
Actuator
Pin
Form No. 56043161 - Clean Track
Cotter
Hair Pin
Cotter
Hair Pin (2)
L24 - 31
®