General Maintenance; Maintenance Schedule - Clarke Clean Track® L24 56317170 Service Manual

General Maintenance

Maintenance Schedule

Maintenance intervals given are for average operating conditions. Machines used in severe operational environments
may require service more often.
Check the Water Level on each Battery Cell
Note: See the individual machine system sections for maintenance information.
* Have Clarke check the vacuum motor carbon brushes once a year or after 300 operating hours. Check the brush
motor and drive motor carbon brushes every 500 hours or once a year.
Warning!
Turn the Key Switch off and disconnect the batteries before servicing the machine.
• Check the vacuum motor carbon brushes once a year or after 300 operating hours.
• Check brush and wheel drive motor(s) carbon brushes (four per motor) once a year or after 500 operating hours.
• The original (new) length of each carbon brush is 1" (25,4mm) on all 24-volt machine models brush and wheel drive
motors.
• Replace the carbon brushes on all motors when the brushes are shorter than 3/8" (9.5mm) to obtain the same motor
efficiency as new brushes.
Important!
Motor damage resulting from failure to service the carbon brushes is not covered under warranty. See the Limited
Warranty Statement.
10 - Form No. 56043161 - Clean Track
Maintenance Item
Charge Batteries
Check/Clean Tanks and Hoses
Check/Clean the Brushes
Clean Vacuum Inlet Screens
Empty and Clean Debris Hopper
Clean Vacuum Shoes
(does not apply to gel cell batteries)
Inspect and Clean Solution Filter
Clean Solution Spray Nozzles
Purge Chemical Mixing System
Lubricate the Machine
* Check the Carbon Brushes
L24
®
Daily Weekly Monthly
X
X
X
X
X
X
X
X
X
X
Yearly
X
X