Touch Button Instructions - Genesis Platinum Alkaline Water Ionizer User Manual

Touch Button Directions
Touch Button
... Alkaline Water button
Steps 1 - 4
Set button
To save changes in setup.
Filtered Only Water Button
Alkaline Water Ionizer
GENESIS Platinum
Mode button
For changing setup.
Acid Water button
Levels 1-4,
Water ON/OFF button
Touch Button Directions
Alkaline Water Buttons Level One Through Four
Touch these sensors to produce alkaline water (water with a pH greater than 7.0). Level one is
on the far left, level four is on the far right, levels two and three are in the middle.
If the voice prompt is turned on, a message tells you what level of alkaline water is being
produced. There are four preset alkaline water levels or steps: first step = pH 8.5, second step =
pH 9.0, third step = pH 9.5 and fourth step = pH 11.0
Mode Button for Changing Genesis Platinum Setup
See "Programming the Genesis Platinum."
Set Button for Saving Changes Made in Mode and also Toggling Between pH and ORP
Display
The pH level or the ORP value of the water being produced is displayed on the LCD screem.
Touch the "Set" touch sensor to switch between pH level and the ORP value.
This button is also used to increase levels you are adjusting in the Mode.
Acid Water Selection Button Levels One Through Four
Touch this sensor to produce acid water (water with a pH less than 7.0). Continue touching the
sensor to increase or decrease the pH level of acid water to be produced.
The selected water is delivered through the stainless steel hose on the top of the product. If the
voice prompt is turned on, a message lets you know what level of acid water is being produced.
There are four preset acidic water levels or steps: first step = pH 6.0, second step = pH 5.0,
third step = pH 4.0 and fourth step = pH 3.0.
The next time you use your product it will have automatically switched back to alkaline water
for safety reasons. Do not drink acid water. You can also use this button to lower settings in the
mode.
Filtered Only Water Selection Button
Touch the purification button, followed by the on/off button to get filtered only water. No
ionization is performed. The pH of the water will be the same as the pH of the supply water
(tap water). Purified water will be delivered through the stainless steel hose. You can also use
this button to increase settings in the mode.
Alkaline Water Ionizer
GENESIS Platinum