Genesis Platinum Alkaline Water Ionizer User Manual page 15

Programming the Genesis Platinum
Programming the Genesis Platinum
The speaker icon will blink. This allows you to (1) set the voice volume or (2) turn off the
voice. Use the "+" (Pure water) touch sensor to increase the voice volume. Use the "- " (Clean)
touch sensor to decrease the voice volume. To turn the voice off continue touching the "-
" (Clean) touch sensor. If you have turned off the voice and want to turn to back on again touch
the "+" ( Pure water) touch sensor and then adjust the volume level by using the "+" and "-
" touch sensors.
Touching the Mode touch sensor ONCE.
Ionization Strength Option
"pH" and "Purifi" will be flashing on the display. This is used to set the initial ionization
strength of the Genesis Platinum. The weakest setting, for water rich in minerals and not hard,
is 6.5. The strongest setting, recommended for hard water and water lacking in minerals is 8.0.
Adjusting this value affects all the pH and ORP levels of the Genesis Platinum. You can fine
tune each individual setting in step 12. We set each Genesis Platinum to 7.0. This is the best
setting for most water in the US. However, if your water is hard, lacking in minerals, or
prestine water like in Hawaii, you may want to make an adjustment here,higher or lower. Test
your pH with your pH testing drops to determin how well the Genesis Platinum is performing
with your tap water. If the ionization is too strong, turn down this setting from 7.0 to 6.5. If the
ionization is too weak, turn up this setting from 7.0 to 7.5 or 8.0.
Touch the Mode touch sensor ONCE.
Filter Change Warning Option
"CL" will blink on the LCD display. This option allows you to adjust how many liters warning
the Genesis gives you to change your filter. The default is 30L, which means when your filter
life gets down to 30L, the Genesis Platinum will tell you it's time to change that filter. You can
adjust this warning signal higher or lower by pushing the + or – buttons. However, we
recommend that you leave it as it is.
Alkaline Water Ionizer
GENESIS Platinum
Programming the Genesis Platinum
Programming the Genesis Platinum
Touch the Mode touch sensor Once.
Preset Alkaline Level pH Adjustment Option
"Alkali" and "pH" will blink. This option allows you to increase or descrease the ionization
strength of each of the four preset alkaline water levels. There are 76 levels of ionization.
Press the #1 alkaline setting and you will see a number between 0 and 18, 0 is the weakest and
18 is the strongest for this #1 alkaline level. If you want more ionization on the #1 alkaline
level, program the number to 18. If you want less ionization, program a number closer to 0.
You can do this for the other three alkaline levels as well. The #2 alkaline setting has a range
between 19 and 38. #3 has a range between 39 and 57. Finally, #4 has a range between 58 and
76.
Touch the Mode touch sensor ONCE.
Preset Alkaline Level OPR Adjustment Option
"Alkali" and "ORP" will blink. This allows you to increase or decrease the ORP value of the
four alkaline preset levels, just like you adjusted the pH value for each of the four settings. The
ORP values are already programmed into your Genesis Platinum so we recommend that you
don't adjust this option.
You are done! Touch the "set" touch sensor to exit product Programming.
Note: When you make any adjustment to an option in the "mode" you must hit "set" to save
the changes you made. If you want to change another option in the "mode," you must go back
into it by pressing the "mode" button for ten seconds, then hitting the "mode" button until the
option is displayed you want to change. Then, after you make your changes, you must hit set
again.
Tip: If you adjust the overall ionization strength of the Genesis Platinum in step 8, it will
change all of your pH and ORP values to their default setting. So, if you want to also fine tune
each pH and ORP value for the four alkaline settings, you must enter the "mode" again, adjust
these values, then hit "set" to save your changes. You cannot adjust multiple options at the
same time. You must reenter the "mode" each time.
GENESIS Platinum
Alkaline Water Ionizer