Installation Instructions; Programming The Genesis Platinum - Genesis Platinum Alkaline Water Ionizer User Manual

Installation Instructions

5) Now, test the pH of your Genesis Platinum. Set the Genesis to alkaline
water level four and collect about 50 ml into a glass. Then locate the red
bottle of pH testing drops and drop in three drops into the glass. The
water should turn purple, indicating a 10+ pH.
Next, set the Genesis Platinum to the number four acid level. Collect the
water. Put in three drops. The color should be orange to red, indicating a
2 to 4 pH.
Tip: To make even stronger acid water, set the Genesis Platinum to the
number four alkaline setting and collect the acid water runoff from the
secondary drain hose. This will be the stongest acid water the Genesis
Platinum can make.
Tip: You can test the other levels of the Genesis Platinum with your
testing drops. Compare them to chart below. Note: color and pH results
will vary based on the temperature, mineral content, TDS, and hardness of
your tap water, so expect some variation in the colors you see. If you
notice a big discrepency, please contact your dealer for information on
prefilters, or reference the resource center in the Water for Life USA
website for a "water problem and solution chart."
Warning: Never drink the water with the pH testing drops in it! If you
do, contact poison control immediately.
Note: The Genesis Platinum automatically cleans itself. You won't see a
cleaning cycle until after a couple months of use, when debris and
minerals begin to build on the plates. This cleaning cycle will keep the
plates relatively clean for a few months. We recommend that you clean
your Genesis Platinum every nine months to one year with the Genesis
Platinum cleaning cartridge, that conveniently fits into the number two
filter slot.
Alkaline Water Ionizer
GENESIS Platinum

Programming the Genesis Platinum

Programming the Genesis Platinum
Programming your product is not necessary since your Genesis Platinum is already set for
optimal performance.
Thing(s) you may want to program are: (1) adjusting the voice volume or muting the voice
(step 6).
You can exit programming at any time by touching the SET touch sensor.
1) Wait for the Genesis to go into the STANDBY mode (LCD display gone dark).ater flow
rate on the Genesis LCD displays reads between 2.0 and 2.5 liters/minute.
LCD Backlight Option
2) Continue touching the
flashes on the display. Switching this option to "ON" will keep the backlight on your Genesis
screen constantly lit. We recommend that you keep this option on "OFF" so that the screen
only lights up when you press a button.
3) Touch the Mode touch sensor ONCE.
Water Direction Option
"Pure" will flash on the LCD display. This option determines the direction that your alkaline
water will flow. We recommend that you don't change this option.
4) Touch the
Volume Control Option
MODE touch sensor until the LCD display lights up and "OFF"
Mode touch sensor ONCE.
Alkaline Water Ionizer
GENESIS Platinum