Advertisement
Q
The plinth facia has two cutting lines.
Screw the plinth facia on with the cut-
ting lines towards the top, and pull
out evenly to adjust to the kitchen
plinth rebate.
Please note:
The plinth facia cannot be pushed
back. It must be unscrewed, so that
both spring clips can be pushed to the
sides and the brackets pushed in.
16
Carefully open the dishwasher door
until the rear bottom edge of the dish-
washer door hits against the plinth
facia.
Place a pencil horizontally at the
front lower edge of the dishwasher
door and draw a horizontal line
across the plinth facia.
Unscrew the plinth facia.
To shorten the plinth facia:
– Trim with the saw along this line,
or better
– cut along one of the cutting lines
provided if this is close enough.
Score the cutting line along the
plinth facia and then break off.
Screw the plinth facia back on to the
brackets, with the cutting line at the
bottom.
If the door does not open smoothly the
plinth facia may need further trimming.
Advertisement
