Advertisement
4. To fit the front panel
Pull the dishwasher out of its recess
enough to allow easy access to the
front panel fixing screws
side.
Push the front panel at an angle
under the control panel
down into the slits of the door front
c
outer panel
.
Make sure that the top edge of the
front panel slides up and sits neatly
in place under the control panel.
Tighten the screws
of the door front outer panel.
Use the stoppers provided to blank
off the openings in the fixing mechan-
ism.
Push the dishwasher back into its
niche.
Usually the front panel will match the kit-
chen furniture in dimensions and col-
our. In this case proceed with Step 7.
However if the colour or measurements
do not match, see the Section "Special
situations".
d
at the
b
and flap
d
on each side
Special situations
The front panel can be matched to the
kitchen furniture fronts as follows:
Case A / Matching colour:
The front panel matches the neighbour-
ing kitchen units for height, but the
decor panel needs to be replaced by
one of a different colour.
To cut a new decor panel to size use
the dimensions set ex works, accord-
ing to the width of the dishwasher.
Then continue with Step 6.
Case B / Matching dimensions:
The front panel dimensions need to be
matched to those of the neighbouring
kitchen units.
Continue with step 5.
Case C / Matching colour and dimen-
sions:
The front panel needs to be matched in
height and colour to the neighbouring
kitchen units.
Continue with Step 5, to find out the
necessary dimensions for cutting the
new decor panel.
Obtain the appropriate decor panel
and then continue with Step 6.
Dimensions set ex-works for decor
panels:
H 603 x W 587 mm (for 60 cm wide
dishwashers)
H 603 x W 437 mm (for 45 cm wide
dishwashers)
Q
11
Advertisement
