Advertisement
Case A / matching colour:
Exchange the decor panel.
Case B / matching dimensions:
Remove decor strips, decor panel,
filler card and polystyrene spacer
pieces, and shorten the panel from
the top by the amount calculated
(26 mm in the example given above).
Please note:
Use masking tape to protect the decor
panel and strips from scratches when
cutting the panel.
Use a cutting tool suitable for the ma-
terial. If necessary take advice from a
suitably competent person.
Case C / Matching colour and dimen-
sions:
As Case B, but do not shorten the
decor panel, replace it with a panel
already cut to size.
When cutting to size, use the height
dimension calculated (X+2 mm) and
the ex-works width dimension given
on page 11, according to your dish-
washer model.
If the new decor panel is thicker than
2 mm (max. 4 mm), remove the filler
card from the front panel.
In all the above-mentioned cases:
Reassemble the front panel and fit to
the machine as described under
Point 4.
Push the dishwasher back into the
niche and align.
Then continue with Step 7.
7. Adjusting the door springs
The door springs are correctly adjusted
when a half opened door (approx. 45°
opening angle) remains in that position
when released.
If the door drops down then the door
springs need to be tightened.
If however it rises up, then the springs
need to be released more.
The adjusting screw is located in the
upper front strip at the left hand side of
the dishwasher.
Open the dishwasher door.
Adjust the door springs using a Torx
screwdriver until it is correctly bal-
anced:
– turn clockwise = tighten
– turn anti-clockwise = loosen.
Q
13
Advertisement
