Track - BOMBARDIER Elan Shop Manual

SECTION 01
} SUB-SECTION 05 (TRACK)
TRACK
TRACK TYPES APPLICATION
Refer to "Technical Data" section 08, 01-05.
REMOVAL
Raise and block rear of vehicle off the ground.
Remove suspension system.
Remove rear axle.
Remove drive axle and withdraw the track from beneath
the vehicle.
INSPECTION
Visually inspect track for cuts and abnormal wear.
Inspect track for broken rods. If excessive damage is
evident and rods are broken, replace track.'
Inspect track for damaged or mlsslnq inserts. Replace
damaged insertls).
I
WARNING: Never run a vehicle with a damaged track. '
Using N°. 5290026 Tool.
F""""W~
Inserts . .
.(
For wide inserts
INSTALLATION
Place inserts into position and, with tool being under
the inserts, tap them over the track using a hammer .
- -.......... Rear
Front ....
411I1----
Raise and block rear of vehicle off the ground. Position
track beneath the vehicle frame tunnel.
O
NOTE:
When installing the track, ensure the right
angle of bearing surface of the track rib is facing
the front of vehicle.
TRACK INSERT INSTALLATION
. Using N°. 4190027 Tool.
Tilt vehicle on its side to expose the track notches then
place insert into position. .
Place the track insert installer into track notches and
position male jig on top of, track insert.
Tighten installer bolt until track insert is locked in place.
I
~
(TRACK), PAGE 1