Settings; Setting The Clock; Witch Off Or On The Rds Time; Tuning And Storing Radio Stations - Grundig UMS 2020 Manual

SETTINGS

Setting­the­clock
The first time you connect the hi-fi system to the
mains, it switches to standby.
1 In standby mode, press and hold »PROG« on
the remote control for 2 seconds.
isplay: »12 H« or »24
– D
2 Press »
« or »
3 4
» « or » « on the remote control to select
5 6
the hour format (12 or 24 hours) and confirm
with »PROG«.
– D isplay: The clock digits for the hours flash.
3 Select the hours with »
hi-fi system or with »
control and confirm with »PROG«.
– D isplay: The clock digits for the minutes flash.
4 Select the minutes with »
the hi-fi system or with »
mote control and confirm with »PROG«.
– D isplay: the current time.
Switch­off­or­on­the­RDS­time­
synchronisation­
Some RDS stations transmit an RDS time signal.
If the selected RDS station transmits time infor-
mation, the time is updated automatically, if you
ON«. This takes about five minutes.
have set »CT
1 Switch on the hi-fi system from standby mode
by pressing » 8 « or »SOURCE«.
2 Select the input source TUNER with »SOURCE«
on the hi-fi system or with »TUNER« on the re-
mote control.
3 Press and hold »DISPLAY« on the remote
control for 2 seconds.
ON« flashes.
– Display: »CT
4 Switch the RDS time synchronisation off or on
with with » « or »
3
or » « or » « on the remote control.
5 6
Notes:
The current time is displayed in standby
7
mode – with reduced brightness.
The time must be reset after a power failure
7
or after disconnecting from the mains.
­ - --------------------------------------------------------------------------------------------------------------------------------------
H«.
« on the hi-fi system or
« or » « on the
3 4
« or » « on the remote
5 6
« or »
3 4
« or » « on the re-
5 6
« on the hi-fi system
4
Tuning­and­storing­radio­stations
You can store up to 30 stations in the FM and
10 stations in the AM frequency range on pre-
sets.
Note:
For the best FM (VHF) reception, it is suffi-
7
cient to direct the wire antenna accordding-
ly.
Programming­radio­stations
1 Switch on the hi-fi system from standby mode
by pressing »
2 Select the input source TUNER by pressing
»SOURCE« on the hi-fi system or by pressing
»TUNER« on the remote control.
« on 3 Select the desired wave range (FM or AM)
by pressing »SOURCE« on the hi-fi system or
»TUNER« on the remote control.
4 Set the radio station by briefly pressing »
or » « repeatedly.
4
– D isplay: the frequency changes in steps of
50 kHz;
or
press and hold down »
the frequency changes to rapid run-through.
5 To store the radio station, press »PROG«, se-
lect preset by pressing
hi-fi system or by pressing »V« or »Λ« on the
remote control and confirm with »PROG«.
6 To search and save more radio stations, repeat
steps 3 to 5.
8 « or »SOURCE«.
« or »
3 4
»+­ PRESET­
ENGLISH
«
3
« until
-« on the
11­