Cutting Mode; The Piece Counter - DURKOPP ADLER 580 Operating Instructions Manual

10.4.5 The cutting mode
10.4.6

The piece counter

34
In the cutting mode, it is possible to switch between the following
parameters:
0 = no cut
CA = cut after sewing
CB = cut before sewing
Keys ñò Skip with the ñò keys to field 1 "cutting mode".
"OK"-key Press the "OK"-key.
The cursor blinks.
Keys ñò Set the desired value with the òñ keys.
"OK"-key Confirm by pressing the "OK"-key.
The buttonhole automat 580 is equipped with a piece counter that
counts the number of buttonholes sewn.
After the "å" sign the current figure is indicated.
The value of the piece counter is memorized also when the automat is
switched off.
The piece counter can count up to 9999 buttonholes. When this figure
is reached the counter restarts at 0.
Resetting the piece counter:
keys ñò Skip with the ñò keys to field 2
"piece counter".
"OK"-key Press the "OK"-key.
The piece counter blinks.
"OK"-key Press the "OK"-key for approx. 1.5 second.
The piece counter is set to 0 and the display changes
back to the main level.
1
2