Too Much Noise In Washing - Haier HLT364XXQ Service Manual

8. Analysis Of The Common Breakdown
No spinning
The washing and
draining are normal.
Check the On/Off point of the
microswitch and stop switch.
Check if the clutch pawl
is pulled enough.
Replace the retarder clutch.
Too much noise in spinning
If the washing machine is set horizontally.
If the hanger is wrongly used.
If the noise of the motor is too much.
If the motor is fastened tightly.
If the noise of the gear case is large.

Too much noise in washing

If the pulsator is rubbing the
bottom of the inner tub.
If the noise of the motor is too much.
If the motor fastened tightly.
If the noise of the retarder is too large.
If the belt is too tight or loose.
MAINTENANCE SERVICE AND TROUBLE SHOOTING
No On/Off point
Normally
Yes
At this time please check
if the drain motor is well.
Yes
No
No
Yes
No
Replace the microswitch
or stop switch.
No
Replace the drain motor.
No
Set the machine horizontally.
Yes
Replace the hanger.
Yes
Replace the motor.
No
Fasten the motor.
Replace the retarder
Adjust the gap between the
Yes
pulsator and inner tub
Yes
Replace the motor.
No
Fasten the motor.
No
Replace the retarder.
Yes
Adjust the belt.