Haier HLT364XXQ Service Manual page 18

C
T
Trouble alarm and solve method
Phenomenan
In pre-wash , the washer stops
running,the numeral tube
shows E0
The draining does not work, or
the speed of draining is too slow
,The numeral tube shows E1
(exclude in peedy).
The machine stops running In
washing ,rinsing or spinning.
The numeral tube shows E2
The safety switch acts. The
spinning can not work (after
amending twice automatically)
The numeral tube shows E3
Not supplying water or the speed
is too slow the suitable water
level doesn't research about 15
minutes.
The numeral tube shows
The waterfall current is poor or
out.
The machine does not act.
(Indicators are off.)
There's abnormal sound inside
the machine.
The water faucet leaks.
The numeral tube shows
Common phenomena
Phenomena
Press the "Process " button to
select "Spin", but it doesn't work.
There may be some water flowing out of
the drain hose in the first use of the machine.
MAINTENANCE SERVICE AND TROUBLE SHOOTING
The reason
The top lid is not closed.
Is the drain hose blocked by foreign
material?
The top lid is not closed.
Are the laundries put slantingly?
Is the machine slanting?
The water faucet is not open or
supplying water is stoped.
The water inlet valve is blocked.
E4
Is the spout blocked by foreign
Does soft wash program selected?
Is the power off?
Does the power cord loose?
Is the machine slanting?
Is some metal inside the washer?
Are the laundries slanting in
spinning?
Is the jointer screw of the water inlet
hose loose or twisted awry?
Overflow alarm
F2
17
How to settle
Close the top lid.
Open and close the top lid once.
Close the top lid.
Re-order the laundries. Close the
top lid.
Level the machine in right position.
Open and close the top lid once.
Open the water faucet.
Push the "Start/Pause" button.
Clean the water inlet valve .
Push the "Start/Pause" button.
Clean the foreign material.
Select the soft wash ,it's normal.
Use it when the power is on.
Insert the power plug tightly.
Level the machine properly.
Fasten the fastener or zip up the zip.
Re-order the laundries.
Fasten the jointer screw properly.
Please contact the after-sales
service department.
Explanation
The program is setting the drain time. Some
time is needed before it starts spinning.
It is the water remained in the factory
inspection of performance.